Another way to do it, if you have room, is to link the sump to the refugium.
If you can raise the refugium above the sump, then drill the refugium
towards the top so it acts as an overflow back into the sump. If you drill
it, you can install a bulkhead and then plumb it back to the sump. Then you
can pump water directly from the sump, into the refugium where it will
overflow back out into the sump. No worries that way. Problem is getting the
top of the refugium higher than the sump.
FWIW
Shane C.
> -----Original Message-----
> From: Jimmy Kuncoro Wardana [SMTP:[EMAIL PROTECTED]]
> Sent: Monday, October 01, 2001 1:37 AM
> To: [EMAIL PROTECTED]
> Subject: RE: refugium plans
>
> > I'm also a bit concerned that if I don't have
> > it hooked
> > into the system correctly, I could get a siphon effect if/when I lose
> > electric power.
>
> Drill the return pipe (from the sump) with 5-6mm bit, at the level of
> water
> surface of your tank. As the power down, the retrun pipe will be filled w/
> air, not water.
>
> Jim.
>
>
>
>
>
>
>
>
>
>
> > TIA
> > Larry
> >
> >
> >
> >
> > >LEAVING THE LIST
> > >================
> > >To stop receiving messages you will need to send a message
> > >to [EMAIL PROTECTED] with a command to remove you
> > from the
> > >list. The list manager controls who belongs to the list.
> > >
> > >For example:
> > > --------------------------------------------------------------
> > > From: John Doe <[EMAIL PROTECTED]>
> > > To: [EMAIL PROTECTED]
> > > Subject: <not needed>
> > >
> > > UNSUBSCRIBE
> > > --------------------------------------------------------------
> >
> >
> > ________________________________________
> >
> > LEAVING THE LIST
> > ================
> > To stop receiving messages you will need to send a message to
> > [EMAIL PROTECTED] with a command to remove you from
> > the list. The list manager controls who belongs to the list.
> >
> > For example:
> > --------------------------------------------------------------
> > From: John Doe <[EMAIL PROTECTED]>
> > To: [EMAIL PROTECTED]
> > Subject: <not needed>
> >
> > UNSUBSCRIBE
> > --------------------------------------------------------------
>
> ________________________________________
>
> LEAVING THE LIST
> ================
> To stop receiving messages you will need to send a message to
> [EMAIL PROTECTED] with a command to remove you from the
> list. The list manager controls who belongs to the list.
>
> For example:
> --------------------------------------------------------------
> From: John Doe <[EMAIL PROTECTED]>
> To: [EMAIL PROTECTED]
> Subject: <not needed>
>
> UNSUBSCRIBE
> --------------------------------------------------------------
________________________________________
LEAVING THE LIST
================
To stop receiving messages you will need to send a message to
[EMAIL PROTECTED] with a command to remove you from the list. The list
manager controls who belongs to the list.
For example:
--------------------------------------------------------------
From: John Doe <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED]
Subject: <not needed>
UNSUBSCRIBE
--------------------------------------------------------------
