I have been having a heck of a time getting my Q202G to tune to 146.xxx. It
was originally set up for 163.xxx and, of course, the plunger rods were cut
off to fit a cabinet. After lengthening the rods, I still couldn't get a
proper notch. Asking around, I was told that I would have to change out the
interconnecting cables between the cans and put in ones that were the right
length electrically. I have some pretty rudimentary test equipment to tune
this thing up so I'm wondering now if I should go ahead and replace the
cables or simply try to get the tuning as accurate as possible with the
equipment I have and leave the cables alone. What are the group's thoughts
on this?
Doug VA7DD
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
