I think I see what you are wanting to do with this system.  Main tx of
the repeater is centrally located and at a good location.  Main rx 
could be at the same location or some other location.  Multiple remote
rx at important locations to fill in holes where mobiles and ht's are
having difficulty in getting into the repeater. 

If the main rx is at a remote location from the main tx it is linked
back to the main tx site via 902 MHz rf.  All remote rx locations are
linked back to main tx site via their own 902 MHz frequency.  

At the main tx site there is a receiver for each link and the output
of each one of these receivers is connected to the voter.  The main rx
audio is also connected to an input to the voter.

In order to make everything sound as smooth as possible when switching
between receivers the remote and main receivers should all be the same
model.  The link transmitters should all be the same model and the 
link receivers should all be the same model.  

All levels should be set as close to identical as possible and all
deviations should be set to as close to the same as possible.

The better this is done the better the system will sound and the more
transparent it will be to your users.

As noted above, all of the remote sites will need a seperate 902 MHz
channel for the link.  This will mean a lot of equipment at the main
site but the payback is that the system will sound good if it is set
up properly.





 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
     http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
     [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
     http://docs.yahoo.com/info/terms/
 


Reply via email to