The problem that you will find is the coax is not 50 Ohm or 75 Ohm. I think it is 90 Ohm, plus the harness has built in load resistors.
I could not find my DB-224E paper work, but I did find the DB-420. They are 100 Ohm, and the coax was 35 Ohm and the resistors were 92 Ohm. The last harness that I purchased from DB was $200.-- including shipping for a DB-224E. It was a full harness and shipped over night. Go to http://www.decibelproducts.com or call them at 800-255-1479 or the Dallas MFG. center at 214-634-8502 and they can give you current prices. Good Luck, Charles Miller, WD5EEH ----- Original Message ----- From: "Mathew Quaife" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Monday, June 14, 2004 11:20 PM Subject: Re: [Repeater-Builder] DB224 Element Impedance Info Needed > Thanks Chuck, got the same answer twice, so must be 100 Ohms. Top half of > the harness appears to be ok, bottom half not so good, going to attempt to > build a harness. Unless the price of a new one is cheap enough, might just > buy one. > > Mathew > > ----- Original Message ----- > From: "Chuck Kelsey" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Monday, June 14, 2004 6:35 PM > Subject: Re: [Repeater-Builder] DB224 Element Impedance Info Needed > > > > I've always been of the understanding that they are 100 ohms each. > > > > Chuck > > WB2EDV > > > > > > > > ----- Original Message ----- > > From: "w9mwq" <[EMAIL PROTECTED]> > > To: <[email protected]> > > Sent: Monday, June 14, 2004 9:20 PM > > Subject: [Repeater-Builder] DB224 Element Impedance Info Needed > > > > > > > Can anyone tell me the impedance of the elements on a DB224 > > > Antenna. I need to rebuild a phasing harnass for an antenna that > > > has been hit by lightning. Any help would be appreciated in this > > > endeavor. > > > > > > Mathew > > > > > > > > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
