Re: [Repeater-Builder] Mastr II

[Ray Rosler]

Thanks thats good news. However in reading all the conversions and doing so, I run into a small problem. I replaced the xtal in 5c icom which was stamped 162.600. the instructions in the alignment state to net the Icom  using a freq counter. The freq I am using is 147.975 - 11.2 = 136.78. This number I am NOT able to get at the test point I am to use. I check the Icom with the other crystal installed and get the number they stated I would expect ot see. My question is, is there a way to make a high freq Icom (162.) work on the (147.), or do I have to t ry and locate a different Icom?   RAy    VE5RAE ----- Original Message ----- From: Steve Grantham To: Repeater-Builder@yahoogroups.com Sent: Sunday, July 11, 2004 9:25 AM Subject: Re: [Repeater-Builder] Mastr II Yes.  There are some performance optimizing tweaks.  However, the 66-split model will work without conversion.  You may wish to join the GE-MastrII group to gather more information.  See the links below.   73, Steve, AA5SG   Supporting websites: http://www.repeater-builder.com/ge/ http://www.nhrc.net/   Yahoo! Groups Links <*> To visit your group on the web, go to:     http://groups.yahoo.com/group/GE-MastrII/ <*> To unsubscribe from this group, send an email to:     [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to:     http://docs.yahoo.com/info/terms/   ----- Original Message ----- From: Ray Rosler To: Repeater Sent: Sunday, July 11, 2004 8:32 AM Subject: [Repeater-Builder] Mastr II I am trying to make a mastrII into a repeater. The model number I have shows it to be a high split. Can this unit be reworked for the 2 meter band. (MC56AAS66A)     Thanks   Ray Yahoo! Groups Links To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/   To unsubscribe from this group, send an email to: [EMAIL PROTECTED]   Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.