Ray, The first thing that you need to do is get the alignment instructions and follow them about 5 times don't worry about "netting" the receiver until you get the receiver to work. also I would advise to get the information on moding the multiplier board and follow it. One change is, you can add the padding caps to bottom of the board with the caps that are already mounted on the board, there are two that aren't there at all, just clean out the holes and add the proper value caps. This is a mod that I have done many times with great results every time. 73 AC0Y
--- In [email protected], Ray Rosler <[EMAIL PROTECTED]> wrote: > I jusst did the net test and no further. will do and advise. Thanks for all the help to date > > Ray > ----- Original Message ----- > From: Q > To: [email protected] > Sent: Sunday, July 11, 2004 4:15 PM > Subject: Re: [Repeater-Builder] Mastr II > > > The Icom makes no difference. Do you get good readings at the first two metering points? You may need to mod the OSC/MULT board. > ----- Original Message ----- > From: Ray Rosler > To: [email protected] > Sent: Sunday, July 11, 2004 6:07 PM > Subject: Re: [Repeater-Builder] Mastr II > > > Thanks thats good news. However in reading all the conversions and doing so, I run into a small problem. I replaced the xtal in 5c icom which was stamped 162.600. the instructions in the alignment state to net the Icom using a freq counter. The freq I am using is 147.975 - 11.2 = 136.78. This number I am NOT able to get at the test point I am to use. I check the Icom with the other crystal installed and get the number they stated I would expect ot see. > My question is, is there a way to make a high freq Icom (162.) work on the (147.), or do I have to t ry and locate a different Icom? > > RAy VE5RAE > > > > > > > > > ------------------------------------------------------------------- ----------- > Yahoo! Groups Links > > a.. To visit your group on the web, go to: > http://groups.yahoo.com/group/Repeater-Builder/ > > b.. To unsubscribe from this group, send an email to: > [EMAIL PROTECTED] > > c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
