Re: [Repeater-Builder] Mastr II

[Ray Rosler]

I jusst did the net test and no further. will do and advise. Thanks for all the help to date   Ray ----- Original Message ----- From: Q To: Repeater-Builder@yahoogroups.com Sent: Sunday, July 11, 2004 4:15 PM Subject: Re: [Repeater-Builder] Mastr II The Icom makes no difference. Do you get good readings at the first two metering points? You may need to mod the OSC/MULT board. ----- Original Message ----- From: Ray Rosler To: Repeater-Builder@yahoogroups.com Sent: Sunday, July 11, 2004 6:07 PM Subject: Re: [Repeater-Builder] Mastr II Thanks thats good news. However in reading all the conversions and doing so, I run into a small problem. I replaced the xtal in 5c icom which was stamped 162.600. the instructions in the alignment state to net the Icom  using a freq counter. The freq I am using is 147.975 - 11.2 = 136.78. This number I am NOT able to get at the test point I am to use. I check the Icom with the other crystal installed and get the number they stated I would expect ot see. My question is, is there a way to make a high freq Icom (162.) work on the (147.), or do I have to t ry and locate a different Icom?   RAy    VE5RAE Yahoo! Groups Links To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/   To unsubscribe from this group, send an email to: [EMAIL PROTECTED]   Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.