Someone correct me if I am wrong here - I haven't worked on a Motrac repeater in a very long time -
Station Logic Module - the diode that connects to pin 3 (anode connects to pin 3) is the Receiver Mute circuit - lifting one end of that diode should leave the receiver unmuted during transmit. Neil Matt wrote: > > Thanks for the info. I have a spare Time Out Timer board too, in > addition to a couple Squelch Gate cards, so I should have the cards > I need for this. Extra cooling is definetly part of the plan too. > > The only other thing is, do you have any suggestions on the easiest > way to get the receiver to stay active while the transmitter is > keyed? Best place to make this mod? Any thoughts on that would be > much appreciated. (Especially since I don't have a service manual > for the unit!) > > Thanks, > > Matt > > --- In Repeater-Builder@yahoogroups.com, "motarolla_doctor" > <[EMAIL PROTECTED]> wrote: > > The part number, 25D84561A01, is the power transformer. > > > > Now, let's see how many Compa base and repeaters have Neil and I > > worked on over the years. > > > > Any way Neil still has the books and can determine which > transformer > > that is. There is also some taps on the secondary to lower the B+ > for > > about 40 or 60 watts. Add a good fan on the PA heatsink and you > should > > be ok. > > > > The 'Tone' decoder is in the receiver, the 'Tone Decoder' in the > card > > cage is most likley the Tone Remote tone decoder.. you probally do > not > > need it. Just need to add the Squelch Gate and Time Out Timmer > boards. > > > Yahoo! Groups Links > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/