N9WYS wrote:
> Hi, all...
>
> OK - I was hoping that 80W would be enough of a drop. Wasn't aware until
> these responses (yours and others) that the MSR PA was not rated for
> Continuous Duty.
>
> I'd have to check the model suffix - I don't remember right off hand.
>
> No - no circulator at this time. Seems SWR was low last we checked it, but I
> can't remember the specific reading - I think it was around 1.3:1, though.
>
> We followed the tuning procedure in the manual. We also used the Motorola
> test panel, so it was literally "by the book"...
>
> Last time we measured it (when we put the PA in the last time) RX
> sensitivity was about .5 �v straight into the receiver, .62 after adding the
> tone panel, and almost 1.0 after adding the duplexers.
>
>
Why would the rx sensitivity change beacuse of the tone panel? That
should have no effect at all...
--
Jim Barbour
WD8CHL
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
