Thanks!! That looks them same to me once I got further in them the were marked on the boards. Looks like I have to go back to the drawing board. Current sense hi and low, I need to find out thier function, is the same a detector and thermal shut back but renamed?
Thanks very much for your help. I machine and lapped the heat sink today so all I have left is hook up of the control wires. Thanks, Jason Mathis --- In [email protected], "Gary" <[EMAIL PROTECTED]> wrote: > > OK, I do not know if this will help. I have the R100 manual > and I have a UHF Maxtrac manual. I know the Maxtrac is not a > Radius, but I believe the PA's are the same. I'm sure someone > will pipe up and correct me if I'm wrong. > > R100 wire color and functions: > > Blue - Thermal shutback > Green - Detector > Yellow - 9.6T > Orange - Control voltage > > Maxtrac UHF 25 watt PA wire color and functions: > > Blue - Current sense Lo > Red - Unswitched B+ > Green - Current sense Hi > Orange - Controlled B+ > Yellow - 9.6T > > I do have a manual for an 25 watt UHF M120 (Radius), but it > shows 6 wires. (go figure!) > > M120 wire color and functions: > > White - Temp sense > Blue - Current sense lo > Red - Unswitched B+ > Green - Current sense Hi > Orange - Controlled B+ > Yellow - 9.6T > > Good luck! > > Gary > > > > > > --- In [email protected], "jason mathis" > <[EMAIL PROTECTED]> wrote: > > > > > > OK the 8w R100 lost its final drive transistor. I happen to come > up > > on a 25w Radius mobile. The boards will not make a direct swap > > because the Mobile's length is slightly longer. So I am taking the > > Mobile's heatsink to work so I can machine it and lap it so it > will > > mate with the big heatsink in the R100. In the R100 coming off the > PA > > deck power filter board there is a 4 wire harness labled CMOS > going > > to the PA board. Now in the Radius mobile there is five wires. can > > someone tell me what these are and the pinout because the colors > are > > reversed on mobile also. > > > > Thanks, > > > > Jason Mathis Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
