I think the point was mistaken here. I either have to change the connector on the receiver so that the cable goes directly to the receiver without using any connetors to change from one type of plug to another, or find a special cable with an RCA on one end and a Type N Male on the other. My objective is to never visit the repeater site once this machine is done. And if I have to, I don't want it to be becuase I used a cheap connector to tie in the reciever. The receiver is the GE MASTR ER41. I'd rather just change the connector to a type N connector, but would have to widdle a little on the internal copper casing to put it in place. Question: If I install the type N connector, and there is a solder point behind the inside, am I going to run into troubles. I hate to cut into it to find that I'm opening a can or worms for noise to get in?
Mathew > > I'm not entirely tongue in cheek when I ask whether you should be in > charge of a repeater or installing one if you have not got the expertise to > cut a bit of coax and fit a plug or socket. And if the spare 20 minutes is > to much for some then that would explain the funny noises I often hear on > two meters whilst traveling around. > 73 de G4DAX (who is too old to allow political correctness to obscure the > view!) > ----- Original Message ----- > From: "russ" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Friday, December 17, 2004 5:06 PM > Subject: Re: [Repeater-Builder] Source for custom made cables > > > > yes but some don't have the time or maybe not the skill to do it. > > > > > > > > > > Yahoo! Groups Links > > > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
