I looked at one of the PL decoder manuals and it says the input requirement
is 45mv RMS minimum. I would start here and see if the input is in spec.
The obvious place to look is the IF being out of alignment, but you changed
that board.
Did you check the 12VDC and 10VDC levels?
Joe
At 01:24 PM 12/24/2004, you wrote:
>Using an HT on the bench if I hit the audio hard getting close to 4.5 KHz
>peaks the repeater would shut down
All outgoing email scanned with Norton AntiVirus2004.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
