Mathew,

When considering RF preamp gain, more is not always better.  I'm not
familiar with the ARR preamp, but if it is a GaAsFET amplifier with 17
dB or so of gain, and your bandpass cavities have 1.5 dB of insertion
loss, I would put either a 6 dB or a 10 dB coaxial attenuator on the
output of the preamp.  A net gain of 6 to 10 dB is usually enough to
improve sensitivity without overloading the existing RF amplifier or
mixer stages.

Unfortunately, there's not a lot you can do about an adjacent-channel
station that is overdeviating.  His peaks are intruding into your
receiver's bandpass, and are valid signals- even though they are
unwanted.  If you have documented proof that another station is
operating outside of "good Amateur practice," perhaps your local
Official Observer needs to get involved.

73, Eric Lemmon WB6FLY

w9mwq wrote:
> 
Everyone remembers my problems I had with a neighbor about 26 miles away
getting into my repeater on the input with his 9 kHz wide
 transmitter, which the GE MASTR receiver took care of that, but I just
installed a ARR preamp, and he is back, and I think I tuned
 them correctly, the DB-4001-2 Filters.  Antenna is up at 90' and can be
accessed about 25 miles away with a Handi-Talki using a rubber duck.  So
the receive is good, but too good.  And I know the problems with
preamps, but was hoping the filters would prevent that.  Any thoughts? 
I am getting no desense on the receiver that I can detect, and that is
with the two hundred watt pa running.  Any ideas other than removing the
preamp back out of line, and yes, I am planning a letter to the Ham
causing interference.
> 
> Mathew
> 
> 
> Yahoo! Groups Links
> 
> 
> 
>





 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




Reply via email to