At 2/23/2005 03:46 PM, you wrote:

>Well it seems that I am told I have to change frequencies, has it
>that one of my users interferred with the same troublesome repeater
>I've had all along, and now the coordinator says I have to move.
>
>Not sure how well all the equipment will handle the change. Here is
>what I have as equipment, and will it all make it there.  We are
>moving from 146.925- to 145.410-, and the expense is the last thing
>I needed right now.
>
>GE MASTR PRO ER41 Receiver

So you'll be dropping the RX about 1.5 MHz.  Never had a problem with the 
VHF Mastr Pro RX I took down to 144.84.

>Vocom Amp, tuned for 146.925
>and then to top if off, I just got the phasing harness for the DB224
>and it was cut right for 146.925.

The phasing harness is broad enough that you won't see a difference at the 
new freq.

>My main transmitter is the (no arguements please), Maggorie HiPro
>transmitter exiting 2 watts to the vocom amp.
>TX RX Duplexers.
>
>How low in frequency will the MASTR Pro go before I loose quality
>sensitivity, right now, it's about .15 uv with a preamp, and
>receives excellent.

It should work fine.  In fact, the preamp ahead of it will make any small 
degradation in the RX noise figure as a result of the move negligible.

>   The vocom amp is model #VVC200-2ref and was
>designed for the 146 Mhz range.
>
>I'm sure the duplexers should not be a problem, other than getting
>them re-tuned.  Thoughts!

I don't see any problems other than all the work involved in retuning 
everything.


>What anger's me the most about this, is that the repeater owner went
>straight to the coordinator, did not bother to talk with me.  I
>changed the PL of the repeater.

Your user may have been getting too good of a signal into the other 
repeater's RX.  Even with everything CTCSS-protected, a user of one 
repeater can still block signals intended for the other system.


>Other sad part is, the user that was getting into their system was
>not getting into the main receiver, but rather a remote site.  I
>wonder how tight his receiver really is, and is it a synthesized
>radio, or something of quality.

If it's on-channel, it doesn't matter so long as the remote RX of the other 
system is coordinated.  A "quality" RX will not reject on-freq. signals 
just because they're "intended" for another repeater.

Bob NO6B






 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 



Reply via email to