How are you powering the unit? Kevin King SCSA BSCIS ARS KC6OVD GMRS KAG0378 EIEIO 2722 Acworth Georgia
-----Original Message----- From: Brent [mailto:[EMAIL PROTECTED] Sent: Tuesday, February 22, 2005 7:45 AM To: Repeater-Builder@yahoogroups.com Subject: Re: [Repeater-Builder] Re: Comm Spec TP-38 Hello Skipp, I have all known tones turned on and active..(double checked that a few times) It will not decode them or show them at all it will show and decode all below 100.0 with no problem, and it does that like it should with no delay.. but if i try the 100.0 it has to have that tone signal present for at least 3 seconds before it will show or decode it.. it is like a audio amp gone bad or some thing.. but i did swap them around and reset the x2122 in the unit and still no difference.. I must be missing some type of failure somewhere.. Brent ----- Original Message ----- From: "skipp025" <[EMAIL PROTECTED]> To: <Repeater-Builder@yahoogroups.com> Sent: Tuesday, February 22, 2005 12:48 PM Subject: [Repeater-Builder] Re: Comm Spec TP-38 > > > Does the tone panel even display frequencies above > 100Hz, just not decode them? That's a software > problem or programing. Most other problems are > hardware related. Just running a test sub tone in > from an external source will tell you mucho. > > skipp > > > "Brent" <[EMAIL PROTECTED]> wrote: > > Question... > > > > Has anybody had a problem with the Communications Specialists TP-38 > Tone > > Panel not decoding PL tones about 100.0hz > > it decodes from below 100.0 just fine and 100.0 but 100.0 is little > slow > > decoding but above 100.0 it just does nothing.. > > > > Thanks > > Brent > > > > > > > > > > > > > > > > > > -- > > No virus found in this outgoing message. > > Checked by AVG Anti-Virus. > > Version: 7.0.300 / Virus Database: 266.2.0 - Release Date: 2/21/2005 > > > > --- > > [This E-mail scanned for viruses at TNWEB LLC] > > > > > > > > > Yahoo! Groups Links > > > > > > > > --- > [This E-mail scanned for viruses at TNWEB LLC] > > > > > -- > No virus found in this incoming message. > Checked by AVG Anti-Virus. > Version: 7.0.300 / Virus Database: 266.2.0 - Release Date: 2/21/2005 > > -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.300 / Virus Database: 266.2.0 - Release Date: 2/21/2005 --- [This E-mail scanned for viruses at TNWEB LLC] Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
