Hello,

If they are the hex type slugs your correct but if they are the small
slotted slugs like in the MVP hand held radios you can usually turn them out
from the bottom.  If the hole does not show up on the PC board you may have
to take the coil off the PC board and remove it that way.

If you are very careful you can break up the hex  slugs and push them out
that way.  I have done that in the past.

Paul


-----Original Message-----
From: Q [mailto:[EMAIL PROTECTED]
Sent: Wednesday, March 16, 2005 4:43 PM
To: [email protected]
Subject: Re: [Repeater-Builder] GE MVP mobile tuning slugs



Usually if the tool wont turn them,then they have already cracked and
will never turn. Usually happens from using the wrong tuning tool or
sometimes they just seize up from old age.Some used paper coil forms
while others were plastic,they both seize up but the paper ones can spin
and rip out the windings. Always use the proper tuning tool!

Larry Lockard wrote:

>Sorry all .... Should have said it was a mobile...I forgot GE was dumb
>enough to give the same designation to different types of radios.
>
>Also the 4 slugs are not only stripped but if like the others on the board
>that I did get loose these will be stuck ....  tight. Pointers before I
>replace them gladly accepted.
>
>I would consider buying a whole radio depending on the price or just
another
>exciter board or if someone has a spare.... GE Custom MVP UHF Mobile -
board
>needs to be capable of moving to 444 mhz area of the ham band (no tripler
>please). As I say I'm going to duplex it and I've told to avoid the tripler
>versions.
>
>Thanks
>Larry
>
>
>
>
>






Yahoo! Groups Links














 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 



Reply via email to