There are a number of initial items, which need to be
properly set up the first time with the S-Comm 7K &
Vyex 7K DAB. Once you get the setup done, the rs-232
port works muy muy bien (great).
1. Use hyperterm and slow down the text send data rate.
I'm using version 6.3, which works just fine.
I configured and saved a connection under the name vyex.
I now simply restart the saved vyex connection.
In hyperterm under File, open the Properties menu, click
on the ASCII setup and set the Character Delay to 120
milliseconds.
To send your information to the Vyex, you can type in
commands direct or send a text file using the Transfer
- Send File command. Direct the open box to the saved
text file you want to send out or type in the commands
direct.
2. I write all my initial settings in a text editor
like windows notepad and send them in hyperterm.
3. Don't extend the single line commands past a half
line. Use a proper command extention mentioned in
the Vyex Manual to continue the command on the next
line.
That should get you started.
****
The Vyex and 7K boot and sync. If you send commands
to the Vyex without Hyperterm properly set up for
a min Character Delay, it will fall out of sync with
the 7K as it tries to follow the too fast inbound
computer data.
As mentioned, be sure to send short lines of
commands, maybe 40 characters across in your
Hyperterm screen and continue them on the following
lines with the \ symbol.
****
The Vyex and 7K combination are just a killer combo.
I now write my config files using a text editor, send
them to the 7k and dial/tweak in the controller operation
per repeater. Once everything is the way I want it....
I capture an image of the 7K ram back onto the vyex
mmc card and transfer it over to my laptop for saving.
The unsupported ram image save/send function works
great! No more lost software setups...
Email me direct if you need more help.
cheers,
skipp025 at yahoo.com
>--- In [email protected], "nj902" <[EMAIL PROTECTED]> wrote:
> I just joined the S-Com list and I posted this question there - but
as
> a new member it has to wait to be moderated so I appologize for
asking
> on two lists but I figure there are some 7K experts here and I hope
I
> can get an answer before I waste too much more time.
>
> I have a very recent S-Com 7000 controller with Vyex DAB and ver
2.04
> controller firmware installed. I have spent countless hours trying
to
> program the 7K through the Vyex serial port using the process
> described in the Vyex documentation on page 23.[i.e. ! {PW} CMD ##]
> None of the commands appeared to work.
>
> What I finally discovered is that if I cold start the 7K by powering
> it on with the reset button held down - then it will accept commands
> and programming from the Vyex serial port - but only until the first
> time the power is cycled to the controller [warm start] or if a
REBOOT
> command is issued from the DAB serial port. After that commands
from
> the serial port do not execute - even though the same command will
> still execute if entered by DTMF.
>
> Is there any way around this problem or am I missing something
simple?
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
