Hello Kevin, yes a file would be great. I need TX: 439.3875 and RX: 431.7875 Today I saw a picture of another T855 but it was different inside. The PCB were the DIP Switch and eprom is located is much bigger in my unit, maybe because of the additional channel switching speaker module.
73 Bernd DM5BM --- In [email protected], "Kevin & Natalia" <[EMAIL PROTECTED]> wrote: > > Bernd, > > I have the Tait T-800 series 1 software here, and I can check and send you a > file of your freq's required. > I have a T-800, which I reprogrammed a number of years ago, and did not have > any problems. > If there are any problems, I can always make a phone call to Tait, as there > are home based here in NZ. > > Regards > > Kevin. ZL1KFM. > > ----- Original Message ----- > From: "Bernd Maestling" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Thursday, November 24, 2005 12:26 PM > Subject: [Repeater-Builder] Help Tait T800 series 1 programming > > > > Hello, > > I hope somebody can help my cause I'm getting nuts > > with programming a Tait series I repeater. > > > > I programmed a few dozend times the 27C64 eproms but > > nothing works. The software I use is PGM800 for DOS > > and also v4.x for Windows. My programmer can program > > BIN files ok, cause I already programmed NOKIA/Kyodo > > BSR450 repeaters in the past. > > > > The setup of my TAIT is: > > RX: T855-20 > > TX: T856-20 > > speaker and channel switch TS0089 (but I use the DIP > > switches in the modules by disconnecting the cables) > > > > I want to programm the modules for somewere between > > 431 and 439 MHz. As I saw, the -20 and -15 modules > > are mostly identical, also are the produced files. > > > > I hope someone can help me. > > > > 73 > > Bernd > > DM5BM > > > > > > > > > > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > > > > > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
