Bernd, I have to apologise. When I made the offer to do a program for you, I thought I had my DOS computer, and the software here, at home. However when I went to get it, I found that I had packed it all away for our up-and-coming house move (in just over 2 weeks) Sorry about that. I do, however see others helping you out, so you should get some results.
Regards Kevin, ZL1KFM. ----- Original Message ----- From: "Bernd Maestling" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Thursday, November 24, 2005 12:52 PM Subject: [Repeater-Builder] Re: Help Tait T800 series 1 programming > Hello Kevin, > > yes a file would be great. I need TX: 439.3875 and RX: 431.7875 > Today I saw a picture of another T855 but it was different inside. > The PCB were the DIP Switch and eprom is located is much bigger > in my unit, maybe because of the additional channel switching > speaker module. > > 73 > Bernd > DM5BM > > > --- In [email protected], "Kevin & Natalia" > <[EMAIL PROTECTED]> wrote: >> >> Bernd, >> >> I have the Tait T-800 series 1 software here, and I can check and > send you a >> file of your freq's required. >> I have a T-800, which I reprogrammed a number of years ago, and did > not have >> any problems. >> If there are any problems, I can always make a phone call to Tait, > as there >> are home based here in NZ. >> >> Regards >> >> Kevin. ZL1KFM. >> Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
