The receiver should be good for at least 2 MHz channel
separation without retuning. An internal
filter/duplexer, if present, might need to be tweaked
a bit on the new transmit frequency for optimum
results.
Bob M.
======
--- Andrew <[EMAIL PROTECTED]> wrote:
> I have an analog MSF5000 (comb# C74CLB7106AT)
> repeater station on
> the ham band already. I have three questions:
>
> 1)Does anybody have the resources to reprogram the
> eprom? (I need
> the frequency changed/CW callsign ID changed). This
> is for HAM, non-
> commercial use only. If you do not want to mention
> it over the list,
> contact me direct at: KC2GOW AT YAHOO DOT COM
>
> 2)I am only moving down 450KHz on the RX and TX
> frequency's. Other
> than the preselector, is their anything that I need
> to adjust after
> the frequency change because of the close spacing?
> (It has been
> tuned/optimized to the original freq. I am moving
> from).
>
> 3)On the analog station, has anyone ever interfaced
> an external
> controller to it, bypassing the internal logic (An
> ACC RC-850)?
> Where is the best place to do this in the station?
> Are there any
> step by step websites someone could refer me to for
> this?
>
> Thanks Guys.
> Andy KC2GOW
__________________________________________
Yahoo! DSL Something to write home about.
Just $16.99/mo. or less.
dsl.yahoo.com
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
