Any perticular reason why you want to run two radios instead of one?
You can do that just fine. Duplex both radios and tune them both up for tx and rx. then use them one tx one rx, but now you have backup radios built in. If the pa dies on one radio you can just swap them in the field and be up and runnng again!
73
Tom
W9SRV
Alexander N Tubonjic <[EMAIL PROTECTED]> wrote:
Alexander N Tubonjic <[EMAIL PROTECTED]> wrote:
Hello,
I am going to be changing a repeater setup a bit and I think it will
work, I would like to get some feedback from you guy's and see what
yall think. Here goes:
The current setup is as follws:
Duplexed 110 Watt Mitrek into controller and Duplexer, Nothing
really fancy.
What I want to do:
Add a second Mitrek in line and have the new one act as RX only
and have the current 110 Watter act as the TX. Now my questions are,
can you run the Mitrek with only one channel element in it (i.e. can I
run the TX Mitrek with only the TX element and the RX Mitrek with only
the RX element in it?) Will I be able to make the Duplexed Mitrek act
as only the TX or would I have to undo the duplex mod?
Like I said, in my mind it should work but I am not sure. Any
thoughts/comments would be appreciated. Thanks.
Alexander
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
What are the most popular cars? Find out at Yahoo! Autos
YAHOO! GROUPS LINKS
- Visit your group "Repeater-Builder" on the web.
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
