Hi
no, I have not connected the cas. The nhrc needs CAS high
so I will try connecting the Rangr RX CAS line pin 12 on the
control plug which goes to around 9v when squelch opens
73
Steve
----- Original Message -----
From: "Coy Hilton" <[EMAIL PROTECTED]>
To: <Repeater-Builder@yahoogroups.com>
Sent: Sunday, February 19, 2006 3:17 AM
Subject: [Repeater-Builder] Re: NHRC-4 Controler
> Do you have the CAS hooked up from your receiver on the radio thay
> you are using for the receiver? If not that would be my guess as to
> why the controller doesn't know that you are talking to it.
>
> 73 and good luck
> AC0Y
>
>
> --- In Repeater-Builder@yahoogroups.com, "Steve Bainbridge"
> <[EMAIL PROTECTED]> wrote:
> >
> > Hi
> > need a bit of help please.
> > I am trying to setup an NHRC-4 to work with
> > 2 Ge Rangrs as a 6mtr rptr.
> > I have connected the Rangr loudspeaker O/P
> > to the nhrc primary a/f input, and the nhrc
> > primary tx a/f to a small amp, so I can hear
> > the tones, cw id etc. I made JP3 and applied 12v
> > for a few seconds, then removed JP3 and from
> > another radio tx,ed into the rptr rx. I the tx,ed
> > again and sent dtmf 1234 to set the password, but I never
> > got the CW OK signal.
> > On the nhrc there are 5 led,s a yellow, green and red, then
> > another green and red. I take it the yellow is dtmf received
> > this is lit when I send dtmf tones. The green is CAS and red
> > is TX primary channel. The 2nd green and red are CAS and TX
> > secondary channel.
> > I take it the CAS is only needed to make the nhrc key the rptr
> > tx and is not needed to program the controller. So any ideas as
> > to why I can't hear the tones, id,s etc
> >
> > 73
> >
> > Steve M1SWB
> >
>
>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.375 / Virus Database: 267.15.11/264 - Release Date: 17/02/06
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
