I agree with the others. Run some shielded audio wire between the two, have
a ball. Consider using gray PVC conduit.
At 06:45 PM 3/19/2006, you wrote:
>Hi,
>Here's the deal. I have two sites...Site one is where my 440 hub
>repeater is located. Site two is where I'm planning to put a 220
>repeater. The distance between the two is about 20-30 yds.
>I need to find a way to link the two together. Doing it on 440 is out
>for several reasons. I could use 900 with a couple of GTX900s or
>similiar but that seems to be a total waste not to mention would cost
>$250-$300. Seems like there should be an alternative to spending that
>kind of money. I also need this to work without attracting a lot of
>attention, ie...putting up antennas outside. The radios would need to
>be able to do CTCSS or DCS.
>
>Someone suggested using telemetry radios. Anyone have any experience
>with those? Someone else said I might be able to do it with hts on low
>power. I have been thinking about 1.2 GHz but can't locate anything
>that would work.
>
>Your suggestions?
>
>Thanks
>Mike K4IJ
>
>
>
>
>
>
>
>
>
>Yahoo! Groups Links
>
>
>
>
Thanks,
Robin Midgett K4IDC
VHF+ Glutton EM66se
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
