[Repeater-Builder] GM300 programing question

[bbedoe]

Hi All!  OK, its silly question time!   Background:   I use a number of UHF Maxtracs for GR300 type operations, links what have you.  I have had no problems programming the little buggers with a pentium 1 233 computer (maybe its a little fast of a computer)   I recent pick up a few UHF GM300's.  The 1st radio I was able to read, change, program all 8 modes with no problems.  I did some on air QSO's.  All was well except I programmed a friends repeater wrong..... went back in changed the FREQ, saved it back to the radio, it beeped at me like normal but now it is now DOA no TX/RX.  The radio powers up, I can go thought all 8 modes (it originally had only 2) but no TX or RX.   I rebooted the computer, reread the radio (all 8 new modes were there) programmed it again, beeped like normal..... still dead!  GRRRRRR!    Yes, I'm aware that Maxtrac and GM300 software is different.  I'm aware of the speed issues, hence the concern that the pent 1 233mhz being a little fast, but I've had no problems with the Maxtracs.  The radios are beeping like normal at the end of the reads/programing, and I'm not getting any error codes.   Any ideas? Brian YAHOO! GROUPS LINKS  Visit your group "Repeater-Builder" on the web.    To unsubscribe from this group, send an email to:  [EMAIL PROTECTED]    Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.