I think, in the program/software, Aux Pin 5 is Flat Tx Audio......of the 16 pin connector!
Charlie
"It is not the class of license the Amateur holds, but the class of the Amateur that holds the license."
Charles Mumphrey
Amateur Radio Station Kc5ozh
Kc5ozh Rowlett Repeater: 441.325 Mhz + 162.2
Kc5ozh Dallas Repeater: 441.950 Mhz + 162.2
Rowlett R.A.C.E.S. Unit 823
http://www.CharliesElectronics.com
http://www.hello-radio.org/
"It is not the class of license the Amateur holds, but the class of the Amateur that holds the license."
Charles Mumphrey
Amateur Radio Station Kc5ozh
Kc5ozh Rowlett Repeater: 441.325 Mhz + 162.2
Kc5ozh Dallas Repeater: 441.950 Mhz + 162.2
Rowlett R.A.C.E.S. Unit 823
http://www.CharliesElectronics.com
http://www.hello-radio.org/
-------- Original Message --------
Subject: [Repeater-Builder] FLAT AUDIO -- GM300 / MAXTRAC
From: [EMAIL PROTECTED]
Date: Fri, April 28, 2006 11:53 am
To: [email protected]
Hi all!Maybe I'm going blind (after reading all the small print of the manual)! or I just missed it somewhere...On the GM300 or Maxtrac:Is there a software spot or a control switch that send flat audio to the 16 pin accessory connector rather than pre-emp audio?Thanks Brian, WD9HSY
YAHOO! GROUPS LINKS
- Visit your group "Repeater-Builder" on the web.
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
