OK – I’m sure you will all think this is a stupid question, but I need to
ask it anyway. (I'm having one of my "stupid moments".)
I’m cobbling together a GTX and a MaxTrac for my 900 project, and I’m using
a Com-Spec TP-3200 as the controller. I need to connect the CTCSS output to
something, but all I have so far are the following connections on the two
radios:
RX Radio (MaxTrac): COR
Audio OUT +
Audio OUT Gnd
TX Radio (GTX): PTT
Audio IN +
Audio IN Gnd
So where do I feed in the CTCSS signal from the TP-3200? The Audio IN + ??
Or do I need to designate another pin on the GTX connector for this purpose?
Thanks,
Mark – N9WYS
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.467 / Virus Database: 269.7.6/814 - Release Date: 5/21/2007
2:01 PM
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/Repeater-Builder/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:[EMAIL PROTECTED]
mailto:[EMAIL PROTECTED]
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
