Keith, KB7M wrote:

> The only hard part (for me) will be making all of the mechanical
> arrangements because the RX and TX must be separated for proper isolation.
> This isn't overwhelming, I'm just not very good at mechanical stuff.  I'm
> thinking I'll take a left-over 2-U rack mount box I've got and build a
> partition down the middle and mount the boards on each side of it.  I'm
> thinking this will isolate them well, provide easy access for tuning and
> maintenance, and provide plenty of aluminum for the PA heatsink (at only 10
> watts, it shouldn't require much).  If I notice it getting warm, I've got
> some heatsink material that can be added to the back of the box for
> additional dissipation.  This arrangement should also provide space for
> ancillary items such as a comspec CTCSS board and possibly the controller
> (TBD).
> 

If you have room, put in two partitions, so that you have an area in the 
middle for interface and/or controller. It'll add a little more 
isolation too.

-- 
Jim Barbour
WD8CHL

Reply via email to