Good idea.  I've got to get the radio in hand, and measure things and see
how it all lays out.
-- 
Keith McQueen
[EMAIL PROTECTED]
801-224-9460

On 11/7/07, Jim <[EMAIL PROTECTED]> wrote:

>   Keith, KB7M wrote:
>
> > The only hard part (for me) will be making all of the mechanical
> > arrangements because the RX and TX must be separated for proper
> isolation.
> > This isn't overwhelming, I'm just not very good at mechanical stuff. I'm
> > thinking I'll take a left-over 2-U rack mount box I've got and build a
> > partition down the middle and mount the boards on each side of it. I'm
> > thinking this will isolate them well, provide easy access for tuning and
> > maintenance, and provide plenty of aluminum for the PA heatsink (at only
> 10
> > watts, it shouldn't require much). If I notice it getting warm, I've got
> > some heatsink material that can be added to the back of the box for
> > additional dissipation. This arrangement should also provide space for
> > ancillary items such as a comspec CTCSS board and possibly the
> controller
> > (TBD).
> >
>
> If you have room, put in two partitions, so that you have an area in the
> middle for interface and/or controller. It'll add a little more
> isolation too.
>
> --
> Jim Barbour
> WD8CHL
>
> 
>

Reply via email to