I ran a repeater on one. But as a ham repeater, there was no remote
control, DC, tone, anything in it. The only cards in the cage were PL,
R1 audio, Squelch Gate, time-out timer, and Station Control. I had the
PL card in and out and the same with the time-out timer
On Feb 6, 2008, at 4:41 PM, skipp025 wrote:
A 100% confirmed in-stone station control module swap?
s.
> Cort Buffington <[EMAIL PROTECTED]> wrote:
>
> I've also done station control cards.
>
> On Feb 6, 2008, at 4:34 PM, skipp025 wrote:
>
> >
> > The only Micor & MSR-2000 Module I know to be an equivalent
> > (less the edge connector) is the Squelch Gate Module. I would
> > not ever plug in any other Module without doing all the proper
> > homework (checking).
> >
> > cheers,
> > skipp
> >
> > > "Tom Manning" <AF4UG@> wrote:
> > >
> > > Hello Kris
> > > Micor station modules can be used in MSR2000 units with this
> > stipulation. You must use msr 2000 connectors on the Micor
modules.
> > I use the connectors from MSR 2000 modules that I would not be
using
> > to go on the Micor modules. This is very helpful to save several
> > dollars. 73 de Tom MAnning, AF4UG
> > > ----- Original Message -----
> > > From: Kris Kirby
> > > To: [email protected]
> > > Sent: Wednesday, February 06, 2008 12:25 AM
> > > Subject: [Repeater-Builder] Micor station modules?
> > >
> > >
> > >
> > > Can Micor station modules be used in an MSR2000 station?
> > >
> > > --
> > > Kris Kirby, KE4AHR <kris@>
> > > But remember, with no superpowers comes no responsibility.
> > > --rly
> > >
> >
> >
> >
>
