Are you programming this out of band? If so, the RSS may not have set points available. You can manipulate the power with the POT on the board (I think it is BLUE colored with white dial) just before the PA. Then you can fine tune the power in the PA with the all white (translucent) pot in the PA. Please keep your emissions clean and do not run the radio below 50 % rated output (55 Watts low band, 50 Watts VHF/UHF if I remember correctly). Also to note, Maratracs and Mitreks do not get any more efficient below 50% output, and sometimes make spurs on the TX output or get "noisy".
hope this helps you .... James Lowell Zabala wrote: > > I just did what u told on the RSS and the power goes down up to 40w on > my power meter when i press F6. Now, the problem when its not > connected to RSS the power reading goes back again to 100w. How can I > really control the ouput? > thanks, > >
