Hello,
I just made a succs on turning down the Power output of the maratrac. Thanks
for all the advice. Now I have another problm on this unit and I still need
your advice , I will use te unit on echolilnk as a radio , i wired the Ptt
Audio in and audio out. Now the problem I encounter is that the recieved audio
is not Decoded even if i Program on the RSS with TPL both on RX and TX. I got
the audio out on J22 pin #5. Tanks in advance for your imediate reply..
lowell
James Delancy <[EMAIL PROTECTED]> wrote: Are you
programming this out of band? If so, the RSS may not have set
points available. You can manipulate the power with the POT on the
board (I think it is BLUE colored with white dial) just before the PA.
Then you can fine tune the power in the PA with the all white
(translucent) pot in the PA. Please keep your emissions clean and do
not run the radio below 50 % rated output (55 Watts low band, 50 Watts
VHF/UHF if I remember correctly). Also to note, Maratracs and Mitreks
do not get any more efficient below 50% output, and sometimes make spurs
on the TX output or get "noisy".
hope this helps you ....
James
Lowell Zabala wrote:
>
> I just did what u told on the RSS and the power goes down up to 40w on
> my power meter when i press F6. Now, the problem when its not
> connected to RSS the power reading goes back again to 100w. How can I
> really control the ouput?
> thanks,
>
>
---------------------------------
Looking for last minute shopping deals? Find them fast with Yahoo! Search.
