RE your message to Sk8ipp - Its not 2x3 method it is a 3x2 method. the first 3 digits are 356 the last 2 are 00 to 99. and you have to triy all of them to find the code it is locked up o( ei: 35600, 35601, 35602, etc.) you also have to wait at least 5 seconds between tries. Once you find the right code then you can enter the program mode and repogram everything including the code.
Doug N3DAB --- In [email protected], "Mike Dietrich" <[EMAIL PROTECTED]> wrote: > > Thanks for the reply skipp, > I had already seen your site from a google search. > The 2&3 trick only puts the panel in the tone translation mode and you can't change anything else > ----- Original Message ----- > From: skipp025 > To: [email protected] > Sent: Monday, June 23, 2008 9:21 PM > Subject: [Repeater-Builder] Re: anyone know backdoor to csi tone panels > > > > Mike, > > Check out my free web page on the subject... and after reading > it I can answer questions as I am/was a Service Station for CSI > Tone Panels. The back door code information is available on the > page below. > > http://www.radiowrench.com/sonic/so02010.html > > and check out the Super 32 and CSI Plus information on the > same sonic page section. > > http://www.radiowrench.com/sonic > > cheers, > skipp > > skipp025 at yahoo.com > > > "Mike Dietrich" <M.DIETRICH@> wrote: > > > > Hi group, > > Does anyone know of a backdoor code or a way to reset the access > code on the CSI-32 (not comm spec) tone panels? > > Any word on where the company went for support? > > They were in Lynnwood, Washington > > > > Thanks, > > Mike > > >
