Are you sure you have the encode board plugged in with a reed plugged in?
--- In [email protected], "n9wys" <[EMAIL PROTECTED]> wrote:
>
> More information about this project.
>
> I have the station working - receiving, decoding proper PL tone,
repeating,
> transmitting audio, etc. The only thing it is NOT doing is encoding
tone
> for transmit. (A reminder - this is a Community Repeater MICOR
chassis, NOT
> the standard repeater chassis.) Anyway - from what I can tell, the
Master
> Control module is NOT sending tone out to the modulator. The
problem I have
> is this: the manual supplement I have shows a different Master Control
> module that what I have. My modules are not IC-based, the ones on the
> manual are. Therefore, I believe the schematic and operation for
the module
> I have is completely different than that in the manual.
>
> Does anyone have an earlier issue of the Community Repeater manual -
> 68P81025E55 (probably revision A, since mine is a "B")? *ALL* I think I
> need are the pages pertaining to the Master Control Module - part
#TLN5803A.
> (Other part numbers may be: TLN8780A or TLN1684A - these are numbers
> stamped on the flange of the card - the first number above was
printed right
> on the circuit board.) The module referenced in my manual is TRN6165A.
>
> For those with a manual - I am seeing tone at Pin 7 ("Tone PL Out")
but not
> at Pin 2 ("Tone or Binary PL to Modulator") on the Master Control
module. I
> tried merely jumpering Pin 7 to Pin 2 - doesn't work. Because the
schematic
> and board layout is completely different, I have no reference to be
able to
> chase signal through the circuit. I'm also wondering if a required
jumper
> is missing or a jumper is improperly installed on my Master Control
card.
>
> Thanks!
> Mark - N9WYS
>
