IIRC there is a front panel pushbutton switch which will interrupt the repeat function allowing the unit to act as a full duplex base station (non-repeat). I think it was marked Repeat/Local.
Just a guess at this point. Mlt N3LTQ ----- Original Message ----- From: "Richard Bessey" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Tuesday, August 26, 2008 8:25 PM Subject: [Repeater-Builder] Uniden ARU-251 > All, > I am hopefull someone can tell me what I am doing wrong. > > I got a Uniden ARU-251 off of Ebay from a fellow ham, all tuned up and > ready to roll as a GMRS repeater form me. > All is well, it showed up and had a loose jumper inside, so it was not > on the correct PL tone. After some diagnostics, I figured that out, and > got the jumper fixed and it was fully operational. I turned it off and > went to bed. The next day, I kick it on to play with it, and it won't > repeat. > I take the cover off and watch the control board, its recieving RX (Per > the LED, and I can hear it on the front speaker), Its getting the proper > tone (Per the LED), yet it will not TX. > > Is there any Uniden ARU-251 pros on the mailing list that could tell me > what to check/test to find the source the problem. Its gotta be > something simple (loose wire, etc...) since one of the jumpers on the > control board came loose during shipment. > > If anyone has any tips I would greatly appreciate any info. > > Regards, > > Richard Bessey > > ------------------------------------ > > > > Yahoo! Groups Links > > >
