Yep, you could add another connector to the "cut-off" parts and re-connect later if needed.
----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[email protected]> Cc: "Chuck Kelsey" <[EMAIL PROTECTED]> Sent: Friday, October 24, 2008 3:35 PM Subject: Re: [Repeater-Builder] DB antenna question > Chuck thanks again. I thought that would be the case. I'll try putting > the splice in the lower section as you suggested and saving the the bottom > TEE (with the orignal pigtail) for returning to the original configuration > if needed, Just more tape and water proofing required to reinstall. > -- > Doug > N3DAB/WPRX486/WPJL709 > > ---- Chuck Kelsey <[EMAIL PROTECTED]> wrote: > > ============= > The only way to use the lower harness and still salvage/save for later is > to > put a dummy load on the connector where the top half of the antenna > connected. Kind of ruins the efficiency. > > Chuck > WB2EDV > > > ----- Original Message ----- > > Subject: RE: [Repeater-Builder] DB antenna question > > >> >> Chuck re: my last message to you and the pigtails - the intent of the >> question was to keep the lower harness still viable for returning to the >> original configuration if I needed to. Cutting a TEE off doesn't let me >> return it to its original operation. >> >> Again thanks for the imput and all other comment you may have. >> -- >> Doug >> N3DAB/WPRX486/WPJL709 >> > > > > ------------------------------------ > > > > Yahoo! Groups Links > > >
