Verify there is a jumper installed on the controller at J5 between pins 1 and 2 if you do not have an audio delay line installed.
Also refer to: http://www.repeater-builder.com/yaesu-vertex-standard/vxr-7000/CAT-Note-11.htm On Sat, Aug 29, 2009 at 3:35 PM, n4zkf<[email protected]> wrote: > OK, let's give this a shot here. I have (tried) to install a CAT 300DXL > controller on my 7000. I programed the repeater to turn off all timers, > tails, ID's, etc. Turned the repeater button (repeat) off and turned on > (remote) button. I programmed the CAT300, EVERYTHING works except the > repeated audio doesn't come thru. You can hear the Voice ID, CW ID, > everything else over the air. You can even program the(CAT)over the air and > it talks back to you as it should. But when someone keys up a radio and tries > to talk thru the repeater, their audio doesn't come out! You can turn up the > volume on the repeater and hear it thru the repeater speaker, but the radio > your listening to on the other end, just sees the carrier and then the > squelch tail and can even hear the courtesy tone as it drops out. But no > repeated audio. Any ideas? This is a big change from my Hamtronics I have > been running for years so I'm lost. I have checked my cable to make sure the > pins are correct. > Cat 6 to VXR 11 (COR). Cat 10 to VXR 12 (PTT). Cat 13 to VXR 6 (RX audio > out). Cat 11 to VXR 3 (TXAudio in). CAT 17 to VXR 14 (ground). > > Any Ideas? thanks 73 Dave n4zkf > > > > ------------------------------------ > > > > Yahoo! Groups Links > > > >
