There may be a receive indicator LED, I bought the pair of them used some time ago mainly because the price was so low I could not pass them up, I'll have fire one up and have a look. I saw a write up many moons ago someone did describing picking the signal up from a point on one of the circuit boards and routing it out the un-used pin on the mic connector. I of course did not have plans to do this back then and did not save it. I have been searching but can't find it. I just downloaded the schematic and will look at that LED circuit if it is there.
Thanks, Robert _____ From: [email protected] [mailto:[email protected]] On Behalf Of DCFluX Sent: Tuesday, April 27, 2010 12:22 AM To: [email protected] Subject: Re: [Repeater-Builder] COR signal from ICOM 37a Didnt those have a green LED on the front panel for COR? On Mon, Apr 26, 2010 at 9:07 PM, Robert McNeill <rob...@ncbfi. <mailto:[email protected]> org> wrote: I want to link two repeaters together and have a couple of Icom 37a 220 rigs on the shelf. I have been searching for info on the best place to grab a signal to drive a COR. Does anyone have any info on this? Thanks!! 73 K5ILS Robert
