Is this system an upgrade from an old version of Riv? There used to be a
sample rate setting inside rd.conf that I don't think is used any more.
Wayne Merricks
The Voice Asia
On 27/06/12 14:34, Mike T. wrote:
> Sorry for taking so long getting back to this. I had a 4 day weekend (:
>
> Anyway, I found the sample rate setting you were talking about in
> version 2 ( Its in SYSTEM SETTINGS) and yes, it was set to 44100 yet I
> still get the fast audio.
>
> Additionally, I did a "speaker-test" like you suggested, and it says the
> rate is set to 480000.
>
> So I made a .asoundrc file and put it in my HOME directory, and I am
> still getting the 48k bitrate. Additionally, I have looked at the wiki
> link you posted, and googled how to change the Alsa rate to 44100, and
> it still is at 48k.
>
> I also created a /etc/asound.conf file with the following:
>
> pcm.!default {
> type hw
> card 0
> rate 44100
> }
>
> ctl.!default {
> type hw
> card 0
> rate 44100
> }
>
> =======
>
> To summarize.
>
> 1. created a /home/rduser/.asoundrc file
>
> 2. created a /etc/asound.conf file
>
> 3.edited /usr/share/alsa/alsa.conf and changed the
> following line as follows:
> defaults.pcm.dmix.rate 44100
>
> 4. speaker-test is still reporting 48000
>
> ==========
>
> Additionally, if I reboot the pc, and don't run rivendell, I can open up
> a wav file that rivendell plays out of the /var/snd folder, and it plays
> just fine. However AFTER rivendell runs, and I close it down, it will
> play at the 48000 bit rate.
>
>
> ========================
>
>
> In version 2 there is a sample rate setting inside edit host somewhere
> (I=
> =20actually looked at it today and still can't remember what section).
> D=
> ouble check that matches 44.1.
>
> Also double check that alsa is set to 44.1 too. Its probably defaulting
> =
> to 48k. If you run speaker-test (apt-get install alsa-tools if its not
> i=
> nstalled already) you'll get some white noise generated but it also
> shows=
> =20you the current sample rate like the following:
>
> speaker-test 1.0.25
>
> Playback device is default
> System parameters are 48000Hz, S16_LE, 1 channels
> Using 16 octaves of pink noise
> Rate set to 48000Hz (requested 48000Hz)
>
> You need to either make a .asoundrc file in your home directory or
> asound=
> .conf inside /etc
>
> The wiki page for asound config is over this way:
> http://www.alsa-project=
> .org/main/index.php/Asoundrc
>
> -----Original Message-----
>
>
> -- Mike
> Station Engineer WVMC-FM
>
> -------------
> http://www.wvmcfm.com
>
> Mansfield 90.7
> Ashland 91.1
> Wooster 102.7
> Butler 99.1
>
>
>
> _______________________________________________
> Rivendell-dev mailing list
> [email protected]
> http://lists.rivendellaudio.org/mailman/listinfo/rivendell-dev
#######################
Scanned by MailMarshal
#######################
############
Attention:
The information contained in this message is confidential and intended
for the addressee(s) only. If you have received this message in error
or there are any problems, please notify the originator immediately.
The unauthorised use, disclosure, copying or alteration of this message
is strictly forbidden. Christian Vision or any of its subsidiaries will
not be liable for direct, special, indirect or consequential damages
arising from alteration of the contents of this message by a third party
or as a result of any virus being passed on. Please note that we reserve
the right to monitor and read any e-mails sent or received by the
company under the Telecommunications (Lawful Business Practice)
(Interception of Communications) Regulation 2000. Christian Vision is
registered in England as a limited company 2842414 and as a charity
1031031
############
_______________________________________________
Rivendell-dev mailing list
[email protected]
http://lists.rivendellaudio.org/mailman/listinfo/rivendell-dev
