Have you had a look at alsa-mixer it sounds like it might be set to different input/output levels.
On 2013-01-28 22:33, Brian P. McGlynn wrote: > Hello, > > I am trying to use Rivendell 2.2.1 with an Audio Card as the audio > router for Satellite-delivered programming. Audio from the satellite > comes into Port 1 (Channels 1, 2: L/R), and is switched in and out to > play on output port 1 - (1,2: L/R) of Rivendell. To activate the > switching, I use the Local Audio Card switcher configured for two > inputs (the audio card has two pairs of In/Out). > > To activate the Satellite Audio, I issue "ST 2 1 1!" as a macro cart. > To stop, I issue "SR 2 1 1!". The Local Audio Card is configured as > Switching Device #2. > > When I issue ST 2 1 1 - Audio begins to pass through on channels L/R > of output 1 and the Left channel of output 2 of the second pair > (channels 1, 2, and 3 of the Delta 44). Further, the audio in Channel > 2 (The Right Channel of Pair 1) is twice the level as Channel 1 and > 3. > > > The card I am using is the Delta 44 with the envy24 driver. When I > bring up the control panel for the Envy, I can see that the incoming > audio is at the correct levels of Input Channel 1 and 2 (L/R for Pair > 1). It is just problematic on the output with this card where channel > 2 is twice the level as channel 1 and 3. Ideally, audio should only > be > coming out of channels 1 and 2. > > Any help/recommendations are greatly appreciated. > > Thanks. > Brian _______________________________________________ Rivendell-dev mailing list [email protected] http://lists.rivendellaudio.org/mailman/listinfo/rivendell-dev
