Hi all:
One of the hex headed machine screws that holds the side/drive rods on
my AM 4-8-4 came loose. I looked for some nut drivers that I thought I
had, but couldn't find them at home (typical). I checked with Micro
Mark and they have a few sets sets, in metric and inch. Has anybody
used either of those and which would be better for the engine side
rods? I assume that the metric would be best since the engines are made
in China - however, maybe the manufacturers (AM, SHS, etc.) might make a
suggestion. Does anyone have any other suggestions besides MicroMark
where I can order them and have them sent to California???
Thanks in advance for any advice.
Rance Velapoldi (Tranby, Norway)
ps Any suggestions for a loc tite material to hold machine screws in?
Might as well order both together.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/S-Scale/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/S-Scale/join
(Yahoo! ID required)
<*> To change settings via email:
[email protected]
[email protected]
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
