Bill, I don't do a ton of solder paste stuff, but recently got back
into it when a local modeler gave a very good clinic on it. I'll
followed his advice and purchased the separate items from Home Depot.
On the two occasions I've used it--it did just fine. I'm not sure of
the brand at this time, but it was strange in that the flux was gray in
color and the solder itself was light brown in color--just the opposite
of what you'd think.
I do like the various PBL silver solder products in rolls (film cans
when I bought them).
Bob Werre
PhotoTraxx
On 8/15/12 10:07 AM, Bill Lane wrote:
For over 20 years I have been using paste solder from PBL. It is great
on small parts. If I had a joint that was not cooperating a small dap
is all it took as it acts as a flux too.
This latest bottle just does not seem to be doing it. Besides being
OMG expensive, it seems to need a lot more heat to burn out and set
up. This bottle says it is silver bearing which I am sure contributes
to the price. I don't necessarily need silver bearing. But I do need
to know that any residue left under the joint won't corrode out and
blow the paint off later.
Does anyone have a source for paste solder for repairing brass models?
I would much prefer someone that has a long history with their brand
solder as well and is happy with it.
Thank You,
Bill Lane
