Are you afraid to lift up a " skirt" to see what is under???? This goes on at all trainshow layouts!!!
John Armstrong ----- Original Message ----- From: Jamie Bothwell To: [email protected] Sent: Monday, September 03, 2012 8:26 AM Subject: Re: {S-Scale List} Psgr car under-sides Tom, Here's basic rundown. In my opinion the most important detail you can add is a BTS 02402 Three Piece Brake Set because these would have been under every car. These were generally grouped together near the car center lengthwise and off set to one side. Probably the most striking visual improvement you can make is the BTS 02407 Truck Brake Cylinders and Torsion Bars. While not strictly an "under-side" part, these are very visible because they are on the trucks. BTS also makes the only available generator, 02425. These sat on the center sill with the drive shaft pointing towards the nearest truck. There should be a drive on the axel that would turn this, but that's getting excessive. Generally there would some battery boxes and some air tanks along either side of the center sill. The Supply Car sells these. BTS lists theirs as parts for heavyweights, but you may find some useful. The Supply Car has two types of water tanks. Either is a good choice unless you know which you want. In general I'd say the 310-009 LW Small APWS Tank is best. These were mounted on the center sill of the car. An air conditioner is a must for lightweight cars, and really for heavyweights in the 1950's. Many railroads used one type of AC unit on all their cars. Larger roads tended to have several types. The Supply Car has a couple varieties of AC units. I believe part 310-003 shown on their website is actually a Waukesha Ice Engine unit. If you use this, you should also use one of the propane cabinets part 310-011 or 310-013 as that was the fuel that powered the unit. Eastern roads seemed leery of these. The PRR would not run them through the tunnels into Penn Station in NYC. AC units were placed along one side of the car. There were also some small control boxes and other bits. BTS offers some other parts like steam lines and end steps that you might want to add. This should get you started. More information available upon request. Jamie Bothwell On Sep 2, 2012, at 3:47 PM, Tom Hawley wrote: I think Jamie recently offered help with under-body equipment placement on passenger cars if one would identify specific cars where this is wanted. (Can't find that specific message right now.) What I had in mind was American Models' first passenger cars, the so-called smooth-side cars. My own modelling needs don't require precise accuracy for specific cars, though that would be nice if easily obtainable. I'd just like to see something under those cars to make them a little more realistic than they are with absolutely nothing down there. Tom Hawley -- Lansing Michigan __________ Information from ESET NOD32 Antivirus, version of virus signature database 7439 (20120902) __________ The message was checked by ESET NOD32 Antivirus. http://www.eset.com
