Yes. The Rail-Lynx chip is now plugged into the chassis plug. It works
just fine.
On Sep 4, 2012, at 6:53 PM, Don Thompson wrote:
Dear Ed,
Did you remove the AC/DC pcb?
Don
On Sep 4, 2012, at 6:42 PM, somothrguy2003 wrote:
Hello Don,
I'm trying to retrofit a Rail-Lynx DCC encoder into an SHS SW1 but
can't fit the chip inside the hood due to the electronics board
mounted inside. The fit of the shell onto the chassis is too tight
with the new chip in place. Since I don't need to plug this upper
electronics board into the lower chassis, is it possible to remove
the upper board without disturbing the connection to the front (or
rear) headlight? How would I remove it if it is possible to do so?
Thanks in advance for the due diligence.
Ed Kenny
(Someday)modeling the DL&W circa 9/29/54 in S scale
