Jason, I'm not sure. I remember that you were helping me look into the recursive Install behavior. Plus, possible parts incompatibility?
I haven't ran the tests on a windows box at all. I don't expect anything new, but it should be done before it ships :) V/R, William On Wed, Jul 29, 2015 at 8:44 AM, Jason Kenny <[email protected]> wrote: > Which MS toolchain on windows do we need tested? I can do a test run > this afternoon. > > Jason > > *From:* William Blevins <[email protected]> > *Sent:* Wednesday, July 29, 2015 1:11 AM > *To:* SCons developer list <[email protected]> > *Subject:* Re: [Scons-dev] Cross-language support > > Happy with it* > > Until the review is complete, and I can perhaps get a few more guinea pigs > to try it out, it's hard to make a concrete projection. I have 3 items > listed out that need to be given a thumbs up/down at a minimum: > > * Item #1 is still mostly outstanding. I'm not sure how to address, > please see the discussion Jason and I started a few weeks ago under the > pull request comments. > > * Item #2 requires no changes (to my knowledge), but someone with more QT > knowledge may say otherwise. > > * I may already have most of the patch for Item #3 (IE. no scanner for > key) based on today's feedback. > > I also still need to request test runs on Windows, and for toolchains that > I may not have installed or instructions to install them (EG. D). > > V/R, > William > > On Wed, Jul 29, 2015 at 1:58 AM, William Blevins <[email protected]> > wrote: > >> As soon as we are happen with it :) >> >> On Wed, Jul 29, 2015 at 12:30 AM, Bill Deegan <[email protected]> >> wrote: >> >>> O.k. let me push 2.3.5 with the visual studio 2015 stuff. >>> Then we'll changed to 2.4 merge slots. stabilize. release. >>> Then this code? (2.5?) >>> >>> -Bill >>> >>> On Tue, Jul 28, 2015 at 6:33 PM, Jason Kenny <[email protected]> wrote: >>> >>>> I have been using the slots drop for a while with Parts. I think it >>>> is ready. It does have a notable improvement in speed and memory size. I >>>> would before getting this out as officially earlier than later. >>>> >>>> Jason >>>> >>>> *From:* William Blevins <[email protected]> >>>> *Sent:* Tuesday, July 28, 2015 8:31 PM >>>> *To:* Dirk Bächle <[email protected]> ; SCons developer list >>>> <[email protected]> >>>> *Subject:* Re: [Scons-dev] Cross-language support >>>> >>>> >>>> >>>> On Tue, Jul 28, 2015 at 7:16 PM, Dirk Bächle <[email protected]> wrote: >>>> >>>>> Hi guys, >>>>> >>>>> sorry for chiming in so late. >>>>> >>>>> On 28.07.2015 23:44, Gary Oberbrunner wrote: >>>>> >>>>>> Yes, that's how we've done it in the past. Sounds like doing it at >>>>>> the same time as slots would be perfect. >>>>>> >>>>>> >>>>> Doing this in parallel with the "slots" change sounds good to me too. >>>>> +1 >>>>> >>>> >>>> I'm not opposed to releasing in the same update as slots, but since the >>>> cross language code reviews haven't been finished, I don't want to delay >>>> slots since it is ready now. >>>> >>>> The pessimist in me as sees doing two major enhancements in the same >>>> release as higher risk; I don't foresee any issues, but its worth the >>>> thought if the release overhead isn't too bad. >>>> >>>> >>>>> >>>>> -- Gary >>>>>> >>>>>> On Tue, Jul 28, 2015 at 2:01 PM, Bill Deegan < >>>>>> [email protected] <mailto:[email protected]>> wrote: >>>>>> >>>>>> Gary, >>>>>> >>>>>> For such a change we should bump the second digit? >>>>>> 2.4? >>>>>> >>>>>> I agree we should not turn down a change because it will cause >>>>>> rebuilds where the past didn't as long as it is now more correct >>>>>> (which it should be with this change). >>>>>> >>>>> >>>>> Yes, "forward" is the way to go. ;) >>>>> >>>>> Also agree we should be verbose in our notification of the impacts >>>>>> of the new change to avoid (as much as we can) "surprises". >>>>>> >>>>>> >>>>> I think (better: hope) we did a good enough job for the "slots" stuff >>>>> on this. For the scanner changes, I see them more like a fix...so a single >>>>> announcement should be sufficient? >>>>> >>>>> Finally, and just in case I haven't done so already, I'd like to thank >>>>> William for all the work he's done on this issue. I couldn't help as much >>>>> as I would've liked, but with Gary's support you tackled this down and >>>>> brought it to a good end. Kudos to you...bravo! >>>>> >>>>> >>>> Truly appreciated. I have spent a lot of time on this issue despite >>>> what one might expect from the number of lines of code. >>>> >>>> It was honestly my first time working in a "real" python environment >>>> outside of scripting, and the SCons code base is rather complex. It >>>> instills me greater appreciation for the work that has already done. >>>> >>>> I also want to thank everyone here for their help past and future, but >>>> don't pat me on the back until its done. I might get lazy :) >>>> >>>> >>>> >>>>> >>>>> Best regards, >>>>> >>>>> Dirk >>>>> >>>>> >>>>> _______________________________________________ >>>>> Scons-dev mailing list >>>>> [email protected] >>>>> https://pairlist2.pair.net/mailman/listinfo/scons-dev >>>>> >>>> >>>> ------------------------------ >>>> _______________________________________________ >>>> Scons-dev mailing list >>>> [email protected] >>>> https://pairlist2.pair.net/mailman/listinfo/scons-dev >>>> >>>> _______________________________________________ >>>> Scons-dev mailing list >>>> [email protected] >>>> https://pairlist2.pair.net/mailman/listinfo/scons-dev >>>> >>>> >>> >>> _______________________________________________ >>> Scons-dev mailing list >>> [email protected] >>> https://pairlist2.pair.net/mailman/listinfo/scons-dev >>> >>> >> > > > ------------------------------ > _______________________________________________ > Scons-dev mailing list > [email protected] > https://pairlist2.pair.net/mailman/listinfo/scons-dev > > > _______________________________________________ > Scons-dev mailing list > [email protected] > https://pairlist2.pair.net/mailman/listinfo/scons-dev > >
_______________________________________________ Scons-dev mailing list [email protected] https://pairlist2.pair.net/mailman/listinfo/scons-dev
