On Sat, Oct 01, 2011 at 05:15:32AM +0530, NaJIm wrote:
*wcte12xp: Setting up global serial parameters for T1*
*wcte12xp: Found a Wildcard TE122*
*wcte12xp: Span configured for ESF/B8ZS*
*wcte12xp: Setting yellow alarm*
Does the highlighted part mean that the card is setup in T1 mode. ??
(
On Friday 30 September 2011, NaJIm wrote:
Am I getting these error messages due to wrong configurations in my
zapata.conf. ??
I have got the following configurations in my zapata-channels.conf.
; Span 1: WCT1/0 Wildcard TE122 Card 0 (MASTER) B8ZS/ESF RED
group=0,11
context=from-pstn
Hi,
As Eric mentioned I made my zapata.conf and zaptel.conf to match each
other.
My *zapata.conf *was
*group=1*
*switchtype=euroisdn*
*signalling=pri_cpe*
*callerid=asreceived*
*usecallerid=yes*
*cidsignalling=dtmf*
*cidstart=ring*
*context=TEST_EXTERNAL*
*channel=1-15*
*channel=17-24*
This
On 9/29/2011 2:52 PM, NaJIm wrote:
IRQ misses: 2
You are risking lots of audio problems if the card shares the IRQ with
any other device. Try and go in the BIOS and disable the other device or
change the IRQ it is using so that they do not conflict.
What version of zaptel are you running?
What
Try module load chan_zap.so in the CLI. You should see whatever errors are
generated.
-Original Message-
From: asterisk-users-boun...@lists.digium.com
[mailto:asterisk-users-boun...@lists.digium.com] On Behalf Of NaJIm
Sent: Thursday, September 29, 2011 5:52 PM
To: Asterisk Users
Mike,
*What version of zaptel are you running?
*
My Zaptel version is - zaptel-1.4.12.1
*What zaptel commands have you tried?
*
None of the zaptel commands are working on my CLI. Its like on CLI, none of
the commands starting with zap are working. (When I give zap+TAB key
nothing shows up)
Hi Eric,
This is the error messages I get I try to load the module.
*CLI module load chan_zap.so
[Sep 30 04:45:57] WARNING[5182]: pbx.c:2979 ast_register_application:
Already have an application 'ZapSendKeypadFacility'
== Parsing '/etc/asterisk/zapata.conf': Found
-- Registered channel 1,
Am I getting these error messages due to wrong configurations in my
zapata.conf. ??
I have got the following configurations in my zapata-channels.conf.
; Span 1: WCT1/0 Wildcard TE122 Card 0 (MASTER) B8ZS/ESF RED
group=0,11
context=from-pstn
switchtype = national
signalling = pri_cpe
channel =
Hello NaJIm,
Your zaptel.conf and zapata.conf files must match as to what channels
and signaling are in use.
See the examples at voip-info:
http://www.voip-info.org/wiki/view/Asterisk+config+zaptel.conf
On 9/29/2011 4:21 PM, NaJIm wrote:
Hi Eric,
This is the error messages I get I try to