Thanks, I have one in the basement. I think it will hold the small bit. Will
give it a try.
- Original Message -
From: chiliblindman
To: blindhandyman@yahoogroups.com
Sent: Monday, January 07, 2008 8:25 AM
Subject: Re:[BlindHandyMan] drill very small hole
After thinking about this I
ALL RIGHT! Here's your perfect excuse to get yourself a Dremel Tool or
something akin to this handy little dandy!
Bill Gallik
E-Mail: [EMAIL PROTECTED]
- The purpose of life is to fight maturity.
- Dick Werthimer
[Non-text portions of this message have been removed]
, 2008 6:38 PM
To: blindhandyman@yahoogroups.com
Subject: Re: [BlindHandyMan] drill very small hole
I think the tape idea will get you in more trouble than it will be worth.
Very hard to roll tape on without lumps and the will make the bit wobble.
An idea you might try is checking with some
Where there's a will, there's a way.
You could drill the little bit through a bit of dowel cut off, so that it's
mostly drill bit sticking out, then tape up toward the dowel to hold securely
enough to get the job done.
I bet you'll figure out a way to get it done.
I think the folks who built the
Most stores have a small chuck mounted on a one quarter inch shaft for holding
tiny bits.
...bob
[Non-text portions of this message have been removed]
Tape would help with the grip but I would be afraid that the bit wouldn't
feed straight.
Without jumping through a bunch of hoops to find some of the reduced shank
drills probably your 1/4 chuck would be the best shot.
-Original Message-
From: blindhandyman@yahoogroups.com [mailto:[EMAIL