SVI counters are currently not supported on ME3800X/ME3600X.
You can use show vlan counters, EVC MIB supported in 15.2(4)S or the
following commands in pre 15.2(4)S release
-snmpwalk -v 2c 7.23.35.39 public .1.3.6.1.2.1.2.2.1.2 | grep 23575
interfaces.ifTable.ifEntry.ifDescr.23575 =
Xu, you didn't see the grep'd output ? :) see below.i was piping to
include only 30 sec
Aaron
-Original Message-
From: Xu Hu [mailto:jstuxuhu0...@gmail.com]
Sent: Wednesday, August 08, 2012 11:21 AM
To: Aaron
Cc: cisco-nsp@puck.nether.net
Subject: Re: [c-nsp] me3600 svi's not
Thanks Reuben. By efp's, I take it you mean the command structure for
Ethernet service instance, bride domain, etc. right ?
Aaron
-Original Message-
From: Reuben Farrelly [mailto:reuben-cisco-...@reub.net]
Sent: Wednesday, August 08, 2012 3:51 PM
To: Aaron
Cc:
Would be great if multicast worked corrected through the efp.
On 8/9/2012 10:19 AM, Aaron wrote:
Thanks Reuben. By efp's, I take it you mean the command structure for
Ethernet service instance, bride domain, etc. right ?
Aaron
-Original Message-
From: Reuben Farrelly
15.2(2)S2 released today for this platform has this as a Fixed defect:
CSCtw79488
Symptoms: Multicast is not forwarded out on EVC.
Conditions: This has been observed with Cisco IOS Release 15.1(2)EY and
EY1a and with the following configuration:
So you may be in luck.
Reuben
On 10/08/2012
anybody know why me3600 svi doesn't seem to show in and out bit counts that
the underlying phy int shows? all svi's (10,11,13) are in a vrf running
over mpls l3vpn
3600#sh int vl 10 | in 30 sec
30 second input rate 2000 bits/sec, 3 packets/sec
30 second output rate 1000 bits/sec, 3
Try to set the load-interval to 30s, then check again.
Thanks and regards,
Xu Hu
On 8 Aug, 2012, at 21:54, Aaron aar...@gvtc.com wrote:
anybody know why me3600 svi doesn't seem to show in and out bit counts that
the underlying phy int shows? all svi's (10,11,13) are in a vrf running
