Be sure you are talking Apples and Apples here. There may be an Orange in
the mix!
The responses you've gotten for calabrating your SWR to match the external
meters are assuming you are putting your tuner in bypass mode. You didn't
say that, and may not be doing so. What you said was press[]
Hello all,
I was asked if repeater contacts are ok for the PB Xmas Event.
Yes, any mode of communication is ok with me.
If you can use two tin cans and a lng string, go for it!
This is meant to be a FUN event. There's only ONE restriction on
operating as a Polar Bear. You MUST operate from
Hello all,
Check out my web page for the
K6XX CW Indicator LED in the WPM+ button.
Click on the links for some great install pictures.
If you want a look go to:
http://www.wa3wsj.com/K6XX/K6XXwpmLED.html
72,
Ed, WA3WSJ
___
Elecraft mailing list
Hello all,
Has anyone installed a SMD LED for the K6XX CW Indicator in a KX1?
If so, could you send me some info about your install and a few pics
to put on my website for others to see.
72,
Ed, WA3WSJ
___
Elecraft mailing list
Post to:
Well...my tilt stand and backlight kit arrived today which I ordered AFTER I
had ordered my K1 and some parts to repair my K2/100/AT.
My disappointment? For some reason the order for the K1 and the K2
replacement parts did NOT get shipped out last Friday as originally planned.
8-(
They are
Hi Gang
Just reading page 59 of the K1 manual and it talks about provisions for
improvements to the VFO temperature compensation
And the use of D3, R17 and R18.
Anyone tried this out and done any before and after tests.
I would be most interested to see if it made any difference, if no one
Hello All and Merry Xmas
Can't figure out where I went wrong here. Attached two 2-D fasteners
to one bare area and one
unbare area as per locations pictured on page 38. Yet when I went
to attach the sides to the RF
board, the only holes that fit are the bare ones, one of which I've
Jeff,
Yes, the long rectangular bare area (previously masked) will go at the
bottom. The other mouning holes may (or may not be) masked, but if masked
they will be short rectangular areas.
Remove the 2D connector from the bare area, then look at the diagrams
carefully.
The words in the
Take a look at the pictures at my Web site and see if that helps:
http://www.craigr.com/coppermine/thumbnails.php?album=32
There's one picture for each page in the manual, generally taken at the end
of the tasks for that page. The one for page 39 looks like it might help.
Craig
NZ0R
K1 #1966
Hi Jeff,
I'm about 10 pages ahead of you in building my K2.
Sounds like you have the 2-D fasteners in the wrong spot(s). If you have the
side (left or right) laying on the table with the inside surface facing up
and the two bare areas toward you, the 2-D fasteners attach to the holes
at the top
10 matches
Mail list logo