Just another viewpoint. I do some contesting using primarily two
K-2/100's. I had a Ten Tec Orion that was a superb radio. I sold it to
order a K-3, but decided to cancel my order. I still may order one, but
I decided that for my purposes, the K-2 is the rig for me. It is simple
to operate,
I bit the bullet and placed my order for a K-3 last week going against my vow
to wait until there was some experience with them. How does one determine
approximate shipping dates on orders? Also, I didn't order any filters not
knowing which ones to order. I sold my Orion (in order to fund the
Ron, I plan to be atop MacDonald Pass (6,500 feet) just outside of Helena, MT
with my Outbacker and my KX-1 (and ATS-3A) as BB#219. So I hope to give you MT
for WAS...73, Ci
Ci Jones, WU7R
FISTS #10789, CC# 1853
SKCC #22, C#38
NAQCC #306
QRPARCI #12163
In a message dated 07/27/07 14:57:11
I have decided not to remote my KPA 100, and therefore have for sale a new
in box EC2 Enclosure and a newly assembled KI02 Aux. I/O. I will sell both for
$140 or $55 for the EC2 and $85 for the KI02 including shipping CONUS. Please
contact me directly via email...thanks, Ci
Ci Jones, WU7R
In a message dated 1/14/2006 8:13:59 AM Mountain Standard Time,
[EMAIL PROTECTED] writes:
Are ham license classes teaching proper procedures anymore?
Sandy, I have been a ham for one and one-half years. There were no ham
classes when I got licensed. Since I only operate CW, I looked
In a message dated 1/11/2006 1:27:55 PM Mountain Standard Time,
[EMAIL PROTECTED] writes:
Fear not the sunspot cycle, Darwin. In the past 18 months, I have completed
WAS with 5w and a dipole. I currently have 49 states with 1 watt, and 44
states with 100mW.
Well, I guess that ends me
In a message dated 1/2/2006 1:15:15 PM Mountain Standard Time,
[EMAIL PROTECTED] writes:
compromised operating situation Kixie (the KX1) was designed for
I use mine in my den next to my TV chair and hooked up to my Windom. I can
listen and have QSO's while my wife and I enjoy our
In a message dated 12/7/2005 9:22:33 AM Mountain Standard Time,
[EMAIL PROTECTED] writes:
There is a poll at http://www.arrl.org asking what percentage of time
we spend operating CW.
Where is the poll on the website? It has smuch stuff, I can't find the
page to which you
I have researched putting my KPA-100 in a seperate enclosure and running my
K-2 in its original mode. However, what seems to me to be a simple project of
extending cables and plugging them in when I need the amplifier is very
complicated according to the reflector. I am not very good at
Thanks to everyone who responded. I think I've got it now. Having it
explained has greatly simplified it for me, and I really appreciate this
reflector.
I need a KIO2 to accomplish the change simply. If somebody has a used one
they would like to sell, I would like to buy one. If I can't
I am considering buying either a T-1 or KAT2 for my K-2. Is there any
comparison data about which is the more effective tuner? Thanks, Ci
Ci Jones, WU7R
FISTS #10789
NAQCC #306
ARCI #12163
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
In a message dated 11/7/05 7:39:51 A.M. Mountain Standard Time,
[EMAIL PROTECTED] writes:
40+ Years of CW SSing and still LOVING IT!
I am a newcomer to all of this, and I am wondering if there is any place
left in contesting for those of us who choose not to have a computer send
Ci Jones
WU7R
FISTS 10789
NAQCC 306
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
In a message dated 11/3/2005 17:02:58 Mountain Standard Time,
[EMAIL PROTECTED] writes:
I guess starting Friday around 7pm or so CW Sweepstakes
starts. Oh well, we have until Friday night to have some fun.
The rules I printed off of the ARRL website say the following: 2.3. Contest
I have a KX-1 (#957) with all options I would like to trade on an FT-817 (I
need two and six meters). If anyone is interested, please contact me
off-reflector. thanks and 72, Ci
Ci Jones
WU7R
FISTS 10789
NAQCC 306
___
Elecraft mailing list
Post
I recently wrote an email to Elecraft re my K-1 transmitting with very weak
power on twenty meters. I got a quick and informative reply back from Gary
suggesting that I use a scope to measure the peak-to-peak voltage on various
pins. Thinking this might provide me with a great learning
In a message dated 7/21/2005 19:52:11 GMT Standard Time,
[EMAIL PROTECTED] writes:
Some oscilloscopes are that way, especially the newer ones!
Thanks again to all who responded. I have printed your advice and I think I
have used the scope successfully to locate the culprit--a bad cap.
My K-1 (#933) has developed a low power situation on twenty meters. It still
receives on all four bands and transmits fine on the other three. When
tuning into a dummy load, it shows 0.1 watts and then indicates low power. I am
not very technically oriented, and I would appreciate any
In a message dated 5/2/05 21:10:53 GMT Daylight Time, [EMAIL PROTECTED]
writes:
Can someone
give me a perfectly good excuse to build a K1? (...Please:-))
I faced the same issue, and I have resolved it by installing the K1 as a
mobile unit in my Jeep. It fits perfectly and works like
Ci Jones
WU7R
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
In a message dated 4/10/05 01:27:34 GMT Daylight Time, [EMAIL PROTECTED]
writes:
You dialed up the colors in the correct order and it gave
you the value of the resistor. It may come in handy during the build.
I have always just used my DMM to check the value of each resister
In a message dated 4/5/05 17:57:03 GMT Daylight Time, [EMAIL PROTECTED]
writes:
I've received a BUNCH of inquiries from folks who (for one reason or the
other) missed out on the LED CW (Zero Beat) Tuning Indicator feeding frenzy
which took place back in Nov-Dec '04 and Jan '05..
This
I just got a bargain KSB2 for my K2 (#4615). It was delivered to the seller
12/5/99. Do I need to make any changes before I install it in my K2. Any
advice will be appreciated. U1 has the following numbers on it - PIC16C72 -
04/SP
and 9852HAN, Also it has a little tag hand written saying
Thanks to all who made suggestions on the reflector. I have ordered a 40
meter hamstick. But in the meantime, I have been using a 24 foot piece of wire
attached to a magnetic mount I have on the roof of my Jeep (I attach it to an
old two meter whip I had).It seems to work okay. I am not yet
Any suggestions for antennas to use for a KX1 from a vehicle? Any
experiences folks have would be helpful...72, Ci
Ci Jones
WU7R
FISTS 10789
NAQCC 306
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to
I went to the suggested website and looked at the pictures. However, there
is no more information about this tuner. Can anyone tell us when the T-1 will
be available and what the price is expected to be?
Ci Jones
WU7R
FISTS 10789
NAQCC 306
___
I am considering using an LDG AT-100Pro or LDG Z-100 tuner with my K-2. My
reasoning is that I haven't upgraded to 100 watts yet, but I need a tuner now.
Also, I operate CW almost exclusively, what other K-2 options would folks
suggest. Any advice and suggestions will be appreciated.
Ci
27 matches
Mail list logo