Inputting 10MHz to K2 but no IF on rear BNC. Measured signal level from
K2 at input of Z1 board is 35mV, on U901 pin 3 level is 10mV, but
'scope shows no signal at pin 6. Connecting K2 IF op to K3 ae input a
very weak oscillation can be heard.
Suspect AD8007 IC has gone, but what signal level
My K2 shows no bargraph deflection on 12m transmit.
Checking on another receiver for radiation can hear the VFO with gain
up, but no variation when power changed from 0.1 to 15w.
All other bands OK, monitor receiver clearly shows change as K2 power
control varied.
Robert
--
Robert Clutson
g0
?
Thanks
Robert
--
Robert Clutson
g0...@operamail.com
--
http://www.fastmail.fm - Accessible with your email software
or over the web
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo
My K2 has no AF output, not even hiss.
I suspected mute circuit but voltages on Q6 Q7 Source 4.8v, gate 1.1v and
drain 4.8v, though low for gate may be within tolerance.
There is 0v on all three of vols 1,2 3 at pins 1,2 3 of P1. Where should
this voltage come from?
The only visible
--
___
Surf the Web in a faster, safer and easier way:
Download Opera 9 at http://www.opera.com
Powered by Outblaze
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to
When using the K2 with PSK I use the computer 9-pin serial port for the PTT.
With only one serial port I then lose the digital read-out from the K2 into my
logging program (LOG-EQF).
Is there any published advice on connecting the K2 digital output to a USB port?
thanks
Robert (g0who)
--
I cannot get beyond the QRP power on 80m (using a dummy load) On 40m get the
full 110 watts also on most other bands.
Following the troubleshooting instructions on page 64 using the MFJ antenna
analyser best SWR is 4.26MHz with SWR at 3.55MHz at 1.2:1
Any suggestions as to where I should look?
Worked F6CNI nr Paris from N England couple of evenings ago using indicated
100mW. Manual says display is accurate to 10%, has anybody experience of
checking this?
Robert (g0who)
--
___
Surf the Web in a faster, safer and easier way:
Download Opera 9
I've reached stage 1 alignment test on K2 (#6257)and have no
bargraph display.
Borrowed another K2, put my front panel board in - Perfect. Put my
control panel in his K2 - no bargraph. Changed MCUs (dangerous
business)- IC is Fine.
What line on the control panel enables the bargraph. What do I
9 matches
Mail list logo